Content for TS 25.331 Word version: 16.1.0
8.5 General procedures Word‑p. 350
8.5.1 Selection of initial UE identity
8.5.2 Actions when entering idle mode from connected mode
8.5.3 Open loop power control upon establishment of DPCCH Word‑p. 352
8.5.4 Physical channel establishment criteria in CELL_DCH state Word‑p. 353
8.5.4A Physical channel establishment criteria for Enhanced Uplink in CELL_FACH state and Idle mode |R8|
8.5.4B Physical channel establishment criteria in CELL_DCH state on the secondary uplink frequency (FDD only) |R9|
8.5.5 Actions in "out of service area" and "in service area" Word‑p. 354
8.5.5.1 Detection of "out of service" area
8.5.5.1.1 Actions following detection of "out of service" area in URA_PCH or CELL_PCH state
8.5.5.1.2 Actions following detection of "out of service" area in CELL_FACH state
8.5.5.1.3 Actions following detection of "out of service" area on transition from CELL_DCH to URA_PCH or CELL_PCH
8.5.5.1.4 Actions following detection of "out of service" area on transition from CELL_DCH to CELL_FACH
8.5.5.2 Detection of "in service" area Word‑p. 355
8.5.5.2.1 Actions following Re-entry into "in service area" in URA_PCH or CELL_PCH state
8.5.5.2.2 Actions following re-entry into "in service area" in CELL_FACH state
8.5.5.3 T316 expiry
8.5.5.4 T317 expiry Word‑p. 356
8.5.6 Radio link failure criteria and actions upon radio link failure
8.5.6a Radio link failure criteria and actions upon radio link failure on the secondary uplink frequency (FDD only) |R9| Word‑p. 357
8.5.7 Open loop power control
8.5.8 Maintenance of Hyper Frame Numbers Word‑p. 361
8.5.9 START value calculation Word‑p. 362
8.5.10 Integrity protection Word‑p. 363
8.5.10.1 Integrity protection in downlink Word‑p. 364
8.5.10.2 Integrity protection in uplink Word‑p. 365
8.5.10.3 Calculation of message authentication code
8.5.11 FACH measurement occasion calculation Word‑p. 366
8.5.11a CELL_DCH measurement occasion calculation (1.28 Mcps TDD only) |R9| Word‑p. 368
8.5.12 Establishment of Access Service Classes
8.5.13 Mapping of Access Classes to Access Service Classes Word‑p. 369
8.5.14 PLMN Type Selection
8.5.14a Neighbour cells list narrowing for cell reselection Word‑p. 370
8.5.15 CFN calculation
8.5.15.1 Initialisation for CELL_DCH state after state transition
8.5.15.2 Initialisation in CELL_DCH state at hard handover
8.5.15.3 Initialisation for CELL_FACH Word‑p. 371
8.5.15.4 Initialisation after intersystem handover to UTRAN
8.5.15.5 Initialisation for MTCH and/or MSCH carried on S-CCPCH that may be soft combined |R6|
8.5.16 Configuration of CTCH occasions
8.5.17 PRACH selection Word‑p. 372
8.5.18 Selection of RACH TTI Word‑p. 373
8.5.18.1 FDD |R4|
8.5.18.2 1.28 Mcps TDD |R4| Word‑p. 374
8.5.19 Secondary CCPCH selection
8.5.19a Secondary CCPCH and FACH selection for MCCH reception |R6| Word‑p. 375
8.5.20 Unsupported configuration
8.5.21 Actions related to Radio Bearer mapping
8.5.22 Actions when entering another RAT from connected mode Word‑p. 383
8.5.23 Measured results on RACH Word‑p. 384
8.5.24 Change of PLMN while in RRC connected mode Word‑p. 387
8.5.25 Actions related to HS_DSCH_RECEPTION variable |R5| Word‑p. 388
8.5.26 Service prioritisation |R6| Word‑p. 390
8.5.27 MBMS frequency selection |R6|
8.5.28 Actions related to E_DCH_TRANSMISSION variable |R6| Word‑p. 392
8.5.29 MBMS modification period identity calculation |R6| Word‑p. 395
8.5.30 Detecting MBMS service reception inability |R6|
8.5.31 Actions related to DEFERRED_MEASUREMENT_STATUS variable |R7| Word‑p. 396
8.5.32 Actions related to MIMO_PARAMS variable |R7|
8.5.33 Actions related to MIMO_STATUS variable |R7| Word‑p. 397
8.5.34 Actions related to DTX_DRX_STATUS variable (FDD only) |R7| Word‑p. 398
8.5.35 Actions related to HS_SCCH_LESS_STATUS variable (FDD only) |R7| Word‑p. 399
8.5.36 Actions related to HS_DSCH_RECEPTION_CELL_FACH_STATE variable (FDD and 1.28 Mcps TDD only) |R7| Word‑p. 400
8.5.37 Actions related to HS_DSCH_RECEPTION_OF_CCCH_ENABLED variable (FDD and 1.28 Mcps TDD only) |R7| Word‑p. 402
8.5.37a Actions related to HS_DSCH_RECEPTION_GENERAL |R7|
8.5.38 Common H-RNTI selection (FDD and 1.28 Mcps TDD only) |R7| Word‑p. 403
8.5.39 PICH selection for HSDPA based paging (FDD and 1.28 Mcps TDD only) |R7|
8.5.40 HS_DSCH Reception in CELL_PCH and URA_PCH (FDD only) |R7| Word‑p. 404
8.5.40a HS_DSCH Reception in CELL_PCH and URA_PCH (1.28 Mcps TDD only) |R8| Word‑p. 405
8.5.41 HS-PDSCH channelisation codes selection for paging reception (FDD and 1.28 Mcps TDD only) |R7| Word‑p. 406
8.5.42 Autonomous UTRAN DRX Cycle length coefficient change |R7| Word‑p. 407
8.5.43 Reception of MBMS from a cell operating in MBSFN mode |R7|
8.5.44 HS-DSCH CQI reporting tables |R7|
8.5.45 Enhanced Uplink in CELL_FACH state and Idle mode (FDD only) |R8|
8.5.45a Enhanced Uplink in CELL_FACH state and Idle mode (1.28 Mcps TDD only) |R8| Word‑p. 410
8.5.46 Actions related to COMMON_E_DCH_TRANSMISSION variable (FDD and 1.28 Mcps TDD only) |R8|
8.5.47 Actions related to READY_FOR_COMMON_EDCH variable (FDD and 1.28 Mcps TDD only) |R8| Word‑p. 413
8.5.48 Actions related to HS_DSCH_DRX_CELL_FACH_STATUS variable (FDD and 1.28 Mcps TDD only) and HS_DSCH_DRX_CELL_FACH_2CYCLE_STATUS variable (FDD only) |R8| Word‑p. 415
8.5.49 CELL_FACH HS-DSCH DRX operation (FDD only) |R8| Word‑p. 416
8.5.49a CELL_FACH HS-DSCH DRX operation (1.28Mcps TDD only) |R8| Word‑p. 417
8.5.49b CELL_FACH HS-DSCH DRX operation with second DRX cycle (FDD only) |R11|
8.5.50 Common E-RNTI selection (1.28 Mcps TDD only) |R8| Word‑p. 419
8.5.51 Actions related to SECONDARY_CELL_HS_DSCH_RECEPTION variable (FDD only) |R8| Word‑p. 420
8.5.52 Actions related to TARGET_CELL_PRECONFIGURATION variable (FDD only) |R8| Word‑p. 421
8.5.53 Actions related to CONTROL_CHANNEL_DRX_STATUS variable (1.28 Mcps TDD only) |R8| Word‑p. 422
8.5.54 Actions related to E_DCH_SPS_STATUS variable (1.28 Mcps TDD only) |R8| Word‑p. 423
8.5.55 Actions related to HS_DSCH_SPS_STATUS variable (1.28 Mcps TDD only) |R8|
8.5.56 Actions related to HSPA_RNTI_STORED_PCH variable (FDD and 1.28 Mcps TDD only) |R8| Word‑p. 424
8.5.57 Actions related to SECONDARY_CELL_MIMO_STATUS variable |R9| Word‑p. 425
8.5.58 Actions related to SECONDARY_CELL_E_DCH_TRANSMISSION variable (FDD only) |R9| Word‑p. 427
8.5.59 Actions related to reception of a HS-SCCH order for secondary uplink frequency activation/deactivation (FDD only) |R9| Word‑p. 429
8.5.60 Configuration of "TSN field extension" for MAC-ehs entity |R9|
8.5.61 Actions related to MU_MIMO_STATUS variable (1.28 Mcps TDD only) |R10| Word‑p. 430
8.5.62 Actions related to MULTI_CARRIER_ E_DCH_TRANSMISSION variable (1.28Mcps TDD only) |R10|
8.5.63 Logged Measurements Configuration |R10| Word‑p. 431
8.5.63.1 General
8.5.63.2 Initiation Word‑p. 432
8.5.63.3 Reception of LOGGING MEASUREMENT CONFIGURATION by the UE
8.5.63.4 T326 Expiry
8.5.63.5 T327 Expiry
8.5.64 UE INFORMATION |R10| Word‑p. 433
8.5.64.1 General
8.5.64.2 Initiation
8.5.64.3 Reception of the UE INFORMATION REQUEST message by the UE
8.5.64.4 Reception of the UE INFORMATION RESPONSE message by the UTRAN Word‑p. 434
8.5.65 Measurements logging |R10|
8.5.66 Release of Logged Measurements Configuration |R10| Word‑p. 435
8.5.66.1 General
8.5.66.2 Initiation Word‑p. 436
8.5.67 Measurements logging for ANR |R10|
8.5.68 Release of ANR Logging Measurements Configuration |R10| Word‑p. 438
8.5.69 Actions related to UPLINK_CLTD_TRANSMISSION variable (FDD only) |R11|
8.5.70 Actions related to UPLINK_OLTD_TRANSMISSION variable (FDD only) |R11| Word‑p. 439
8.5.71 Actions related to MULTIFLOW_STATUS variable (FDD only) |R11|
8.5.72 Selection of common E-DCH TTI (FDD only) |R11| Word‑p. 440
8.5.73 PRACH preamble control parameters selection with Concurrent Deployment of 2ms and 10ms TTI (for Enhanced Uplink, FDD only) |R11| Word‑p. 441
8.5.74 PRACH preamble control parameters selection without Concurrent Deployment of 2ms and 10ms TTI (for Enhanced Uplink, FDD only) |R11| Word‑p. 443
8.5.75 Actions related to READY_FOR_COMMON_ERGCH variable (FDD only) |R11| Word‑p. 444
8.5.76 Actions related to FALLBACK_R99_PRACH_ENABLED variable (FDD only) |R11| Word‑p. 445
8.5.77 Actions related to READY_FOR_FALLBACK_R99_PRACH variable (FDD only) |R11|
8.5.78 Actions related to MIMO_MODE_WITH_FOUR_TRANSMIT_ANTENNAS_PARAMS variable (FDD only) |R11| Word‑p. 446
8.5.79 Actions related to MIMO_MODE_WITH_FOUR_TRANSMIT_ANTENNAS_STATUS variable(FDD only) |R11| Word‑p. 447
8.5.80 Actions related to SECONDARY_CELL_MIMO_MODE_WITH_FOUR_TRANSMIT_ANTENNAS_STATUS variable (FDD only) |R11| Word‑p. 448
8.5.81 Actions related to UPLINK_MIMO_TRANSMISSION variable (FDD only) |R11| Word‑p. 449
8.5.82 Actions related to NON_RECTANGULAR_RESOURCE_ALLOCATION_STATUS variable (1.28 Mcps TDD only) |R12| Word‑p. 450
8.5.83 Actions related to DPCCH2_TRANSMISSION variable (FDD only) |R12|
8.5.84 Actions related to DCH_ENHANCEMENTS_STATUS variable (FDD only) |R12| Word‑p. 451
8.5.85 Actions related to IMPLICIT_GRANT variable (FDD only) |R12| Word‑p. 452
8.5.86 Actions related to reception of a HS-SCCH order for TTI switching (FDD only) |R12|
8.5.87 Actions related to BLIND_HARQ_HSDPA variable (FDD only) |R13| Word‑p. 453
8.5.88 Actions related to HS_SCCH_DRX_CELL_FACH_STATUS variable (FDD only) |R14|
8.5.89 HS-SCCH DRX operation in CELL_FACH state (FDD only) |R14| Word‑p. 454
