TS 31.120
UICC-Terminal Interface –
Physical, Electrical and Logical Test specification
V17.0.0 (PDF)
2022/03 10 p.
V16.0.0
2020/06 10 p.
V15.0.0
2018/06 10 p.
V14.0.0
2017/03 10 p.
V13.0.0
2016/01 10 p.
V12.0.0
2014/10 10 p.
V11.0.0
2012/10 10 p.
V10.0.0
2011/04 10 p.
V9.0.0
2009/12 10 p.
V8.1.0
2009/12 10 p.
V7.0.0
2007/06 10 p.
V6.0.0
2005/01 10 p.
V5.0.0
2005/01 10 p.
V4.0.0
2005/01 10 p.
V3.1.0
2005/01 10 p.
- Rapporteur:
- Mr. Phan, Ly Thanh
Gemalto N.V.
Content for TS 31.120 Word version: 16.0.0
0 Introduction Word‑p. 4
The present document defines the interface tests for the Terminal / UICC interface.
The aim of the present document is to ensure interoperability between an UICC and a Terminal independently of the respective manufacturer, card issuer or operator.
Application specific tests for applications residing on an UICC are specified in document TS 31.121.
1 Scope Word‑p. 5
The present document specifies the interface test for the Terminal / UICC.
The present document specifies the tests of:
- physical characteristics of the UICC;
- the electrical interface between the UICC and the Terminal;
- the initial communication establishment and the transport protocols;
- the application independent procedures.
2 References
The following documents contain provisions which, through reference in this text, constitute provisions of the present document.
- References are either specific (identified by date of publication, edition number, version number, etc.) or non specific.
- For a specific reference, subsequent revisions do not apply.
- For a non-specific reference, the latest version applies. In the case of a reference to a 3GPP document (including a GSM document), a non-specific reference implicitly refers to the latest version of that document in the same Release as the present document.
3 Definitions, symbols, abbreviations and coding
All definitions, symbols, abbreviations and coding conventions applicable to the terminal are specified in ETSI TS 102 230 [1].
4 Physical Characteristic Tests
All tests within the scope of this clause are specified in ETSI TS 102 230 [1].
5 Electrical Characteristic Tests
All tests within the scope of this clause are specified in ETSI TS 102 230 [1].
6 Initial Communication Tests Word‑p. 6
All tests within the scope of this clause are specified in ETSI TS 102 230 [1].
7 Transmission Protocol Tests
All tests within the scope of this clause are specified in ETSI TS 102 230 [1].
8 Application independent procedures
All tests within the scope of this clause are specified in ETSI TS 102 230 [1].
A (Normative) UICC simulator functional requirement Word‑p. 7
UICC simulator functional requirement
All requirements within the scope of this clause are specified in ETSI TS 102 230 [1].
$ Change History Word‑p. 8
