Tech-invite   3GPPspecs   RFCs   Search in Tech-invite

Gen21222324252627282931323334353637384‑5x
FsNEsRPsSBIsIDs Ti+
Top   in Index   Prev   Next

TS 38.101-3 (RAN4)
5G New Radio —
User Equipment Radio Transmission and Reception
Part 3: Range 1 and Range 2 Interworking Operation with other Radios

use "3GPP‑Page" to get the Word version
use "ETSI‑search" to get the PDF version
the ToC, based on the Word version, is reproduced for a better overview
V16.1.0 (Wzip)2019/09  282 p.
V15.7.0 (PDF)2019/09  176 p.

Rapporteur:  Mr. Vintola, Ville
See also:
TS 36.101   for E-UTRA

The present document establishes the minimum RF characteristics and minimum performance requirements for NR User Equipment (UE) Interworking operation with other radios. This includes but is not limited to additional requirements for carrier aggregation between Range 1 and Range 2 and additional requirements due to NR non-standalone (NSA) operation mode with E‑UTRA.
The present document is interwork specification for NR UE, covering RF characteristics and minimum performance requirements. Conformance to the present specification is demonstrated by fulfilling the test requirements specified in the conformance specification TS 38.521-3.
The Minimum Requirements given in this specification make no allowance for measurement uncertainty. The test specification TS 38.521-3 defines test tolerances. These test tolerances are individually calculated for each test. The test tolerances are used to relax the minimum requirements in this specification to create test requirements. For some requirements, including regulatory requirements, the test tolerance is set to zero.
The measurement results returned by the test system are compared - without any modification - against the test requirements as defined by the shared risk principle.
The shared risk principle is defined in Recommendation ITU-R M.1545.

short Table of Contents for  TS 38.101-3  Word version:   16.1.0

each title links to the equivalent title in the full ToC

 

Here   Top

 

1  ScopeWord-p. 10
2  ReferencesWord-p. 10
3  Definitions, symbols and abbreviationsWord-p. 10
4  GeneralWord-p. 12
5  Operating bands and channel arrangementUpWord-p. 13
5.1  GeneralWord-p. 13
5.2  Operating bandsWord-p. 14
5.2A  Operating bands for CAWord-p. 14
5.2B  Operating bands for DCWord-p. 15
5.3  UE Channel bandwidthWord-p. 15
5.3A  UE Channel bandwidth for CAWord-p. 15
5.3B  UE Channel bandwidth for EN-DCUpWord-p. 15
5.4Void
5.4A  Channel arrangement for CAWord-p. 18
5.4B  Channel arrangement for DCWord-p. 18
5.5  ConfigurationWord-p. 20
5.5A  Configuration for CAWord-p. 20
5.5B  Configuration for DCWord-p. 38
6  Transmitter characteristicsWord-p. 120
6.1  GeneralWord-p. 120
6.2Void
6.2A  Transmitter power for CAWord-p. 121
6.2B  Transmitter power for DCWord-p. 122
6.3  Output power dynamicsWord-p. 176
6.3A  Output power dynamics for CAUpWord-p. 176
6.3B  Output power dynamics for DCWord-p. 176
6.4Void
6.4A  Transmit signal quality for CAWord-p. 179
6.4B  Transmit signal quality for DCWord-p. 180
6.5Void
6.5A  Output RF spectrum emissions for CAWord-p. 182
6.5B  Output RF spectrum emissions for DCUpWord-p. 182
6.6B  Beam correspondence for DCWord-p. 204
7  Receiver characteristicsWord-p. 204
7.1  GeneralWord-p. 204
7.2Void
7.3Void
7.3A  Reference sensitivity for CAWord-p. 206
7.3B  Reference sensitivity level for DCWord-p. 207
7.4Void
7.4A  Maximum input level for CAWord-p. 251
7.4B  Maximum input level for DC in FR1Word-p. 251
7.5Void
7.5A  Adjacent channel selectivity for CAWord-p. 252
7.5B  Adjacent channel selectivity for DC in FR1Word-p. 253
7.6Void
7.6A  Blocking characteristics for CAWord-p. 255
7.6B  Blocking characteristics for DC in FR1Word-p. 255
7.7Void
7.7A  Spurious response for CAWord-p. 259
7.7B  Spurious response for DC in FR1UpWord-p. 259
7.8Void
7.8A  Intermodulation characteristics for CAWord-p. 260
7.8B  Intermodulation characteristics for DC in FR1Word-p. 260
7.9Void
7.9A  Spurious emissions for CAWord-p. 261
7.9B  Spurious emissions for DC in FR1Word-p. 261
A (Normative)  Measurement channelsWord-p. 263
BVoid
CVoid
DVoid
EVoid
FVoid
GVoid
H (Normative)  Modified MPR behaviorWord-p. 275
I (Normative)  Dual uplink interfererWord-p. 276
JVoid
KVoid
L  Change historyWord-p. 277

Up   Top