Tech-invite  3GPPspace  IETFspace
◀  ▶  21  22  23  24  25  26  27  28  29  31  32  33  34  35  36  37  38  4‑5x
Top   in Index   Prev   Next

TS 25.104
3G UTRA —
Frequency Division Duplex (FDD) mode –
Base Station Radio Transmission and Reception

3GPP‑Page   ETSI‑search   fToC↓   Partial Content →
V19.0.0 (PDF)  2025/09  133 p.
V18.0.1  2024/06  134 p.
V17.0.1  2024/06  134 p.
V16.0.1  2024/06  133 p.
V15.5.1  2024/06  134 p.
V14.2.1  2024/06  129 p.
V13.4.1  2024/06  129 p.
V12.7.0  2016/01  117 p.
V11.12.0  2016/01  115 p.
V10.8.0  2013/01  96 p.
V9.9.0  2013/01  90 p.
V8.14.0  2012/07  85 p.
V7.13.0  2009/09  73 p.
V6.18.0  2009/06  65 p.
V5.13.0  2007/03  51 p.
V4.9.0  2007/03  43 p.
V3.14.0  2007/03  41 p.
Rapporteur:
Mr. Skold, Johan
Ericsson LM

full Table of Contents for  TS 25.104  Word version:  19.0.0

each clause number in 'red' refers to the equivalent title in the Partial Content
Here   Top
1Scope  p. 8
2References  p. 8
3Definitions and abbreviations  p. 8
3.1Definitions  p. 8
3.2Abbreviations  p. 10
3.3Symbols |R11|  p. 11
4General  p. 12
4.1Relationship between Minimum Requirements and Test Requirements  p. 12
4.2Base station classes  p. 12
4.3Regional requirements  p. 13
4.4Environmental requirements for the BS equipment  p. 14
4.5Applicability of requirements |R9|  p. 14
4.6Requirements for contiguous and non-contiguous spectrum |R11|  p. 14
4.7Requirements for BS capable of multi-band operation |R11|  p. 15
5Frequency bands and channel arrangement  p. 15
5.1General  p. 15
5.2Frequency bands  p. 16
5.3Tx-Rx frequency separation  p. 18
5.4Channel arrangement  p. 19
5.4.1Channel spacing  p. 19
5.4.2Channel raster  p. 19
5.4.3Channel number  p. 19
6Transmitter characteristics  p. 21
6.1General  p. 21
6.2Base station output power  p. 22
6.2.1Base station maximum output power  p. 22
6.2.1.1Minimum requirement  p. 22
6.3Frequency error  p. 23
6.3.1Minimum requirement  p. 23
6.4Output power dynamics  p. 23
6.4.1Inner loop power control in the downlink  p. 23
6.4.1.1Power control steps  p. 23
6.4.1.1.1Minimum requirement  p. 23
6.4.2Power control dynamic range  p. 24
6.4.2.1Minimum requirements  p. 24
6.4.3Total power dynamic range  p. 24
6.4.3.1Minimum requirement  p. 24
6.4.4Primary CPICH power  p. 24
6.4.4.1Minimum requirement  p. 24
6.4.4ASecondary CPICH power |R10|  p. 24
6.4.4A.1Minimum Requirement for MIMO mode  p. 24
6.4.4A.2Minimum Requirement for MIMO mode with four transmit antennas |R11|  p. 25
6.4.4BDemodulation CPICH power for MIMO mode with four transmit antennas |R11|  p. 25
6.4.4B.1Minimum Requirement  p. 25
6.4.5IPDL time mask |R4|  p. 25
6.4.5.1Minimum Requirement  p. 25
6.4.6Home base station output power for adjacent channel protection |R8|  p. 26
6.4.6.1Minimum requirement  p. 27
6.5Void  p. …
6.6Output RF spectrum emissions  p. 27
6.6.1Occupied bandwidth  p. 27
6.6.1.1Minimum requirement |R6|  p. 27
6.6.2Out of band emission  p. 27
6.6.2.1Spectrum emission mask  p. 27
6.6.2.2Adjacent Channel Leakage power Ratio (ACLR)  p. 33
6.6.2.2.1Minimum requirement  p. 33
6.6.2.2.2Cumulative ACLR requirement in non-contiguous spectrum |R11|  p. 34
6.6.3Spurious emissions  p. 35
6.6.3.1Mandatory Requirements  p. 35
6.6.3.1.1Spurious emissions (Category A)  p. 35
6.6.3.1.2Spurious emissions (Category B)  p. 36
6.6.3.2Protection of the BS receiver of own or different BS  p. 37
6.6.3.2.1Minimum Requirement  p. 37
6.6.3.3Co-existence with other systems in the same geographical area  p. 39
6.6.3.3.1Minimum Requirements  p. 40
6.6.3.4Co-existence with co-located and co-sited base stations  p. 44
6.6.3.4.1Minimum Requirements  p. 45
6.6.3.5Co-existence with PHS  p. 53
6.6.3.5.1Minimum Requirement  p. 53
6.6.3.6Co-existence with services in adjacent frequency bands  p. 53
6.6.3.6.1Minimum requirement  p. 53
6.6.3.7Void  p. …
6.6.3.8Protection of Public Safety Operations |R8|  p. 54
6.6.3.8.1Minimum Requirement  p. 54
6.6.3.9Co-existence with Home BS operating in other bands |R8|  p. 54
6.6.3.9.1Minimum Requirements  p. 55
6.7Transmitter intermodulation  p. 56
6.7.1Minimum requirement  p. 56
6.8Transmit modulation  p. 57
6.8.1Transmit pulse shape filter  p. 57
6.8.2Error Vector Magnitude  p. 57
6.8.2.1Minimum requirement  p. 57
6.8.3Peak code Domain error  p. 57
6.8.3.1Minimum requirement  p. 57
6.8.4Time alignment error |R5|  p. 58
6.8.4.1Minimum Requirements  p. 58
6.8.5 Relative Code Domain Error for 64QAM modulation |R7|  p. 58
6.8.5.1Minimum requirement  p. 58
7Receiver characteristics  p. 58
7.1General  p. 58
7.2Reference sensitivity level  p. 59
7.2.1Minimum requirement  p. 59
7.2.2Maximum Frequency Deviation for Receiver Performance  p. 59
7.3Dynamic range  p. 59
7.3.1Minimum requirement  p. 59
7.4Adjacent Channel Selectivity (ACS)  p. 60
7.4.1Minimum requirement  p. 60
7.4.2Minimum requirement - Co-location with UTRA-TDD  p. 60
7.5Blocking characteristics  p. 60
7.5.1Minimum requirement  p. 60
7.5.2Minimum Requirement - Co-location with GSM, DCS, PCS, CDMA, UTRA and/or E-UTRA, UTRA TDD, E-UTRA TDD and/or NR  p. 68
7.5.3Void  p. …
7.6Intermodulation characteristics  p. 77
7.6.1Minimum requirement  p. 77
7.7Spurious emissions  p. 79
7.7.1Minimum requirement  p. 79
8Performance requirement  p. 80
8.1General  p. 80
8.2Demodulation in static propagation conditions  p. 81
8.2.1Demodulation of DCH  p. 81
8.2.1.1Minimum requirement  p. 81
8.3Demodulation of DCH in multipath fading conditions  p. 81
8.3.1Multipath fading Case 1  p. 81
8.3.1.1Minimum requirement  p. 81
8.3.2Multipath fading Case 2  p. 81
8.3.2.1Minimum requirement  p. 82
8.3.3Multipath fading Case 3  p. 82
8.3.3.1Minimum requirement  p. 82
8.3.4Multipath fading Case 4  p. 82
8.3.4.1Minimum requirement  p. 83
8.4Demodulation of DCH in moving propagation conditions  p. 83
8.4.1Minimum requirement  p. 83
8.5Demodulation of DCH in birth/death propagation conditions  p. 83
8.5.1Minimum requirement  p. 84
8.5ADemodulation of DCH in high speed train conditions |R7|  p. 84
8.5A.1General  p. 84
8.5A.2Minimum requirement  p. 84
8.6Void  p. …
8.7Performance requirement for RACH |R4|  p. 84
8.7.1Performance requirement for RACH preamble detection  p. 84
8.7.2Demodulation of RACH message  p. 85
8.7.2.1Minimum requirements for Static Propagation Condition  p. 85
8.7.2.2Minimum requirements for Multipath Fading Case 3  p. 85
8.7.2.3Minimum requirements for high speed train conditions |R7|  p. 86
8.8Void  p. …
8.9Void  p. …
8.10Performance of ACK/NACK detection for HS-DPCCH |R6|  p. 86
8.10.1ACK false alarm  p. 86
8.10.2ACK mis-detection  p. 87
8.10APerformance of ACK/NACK detection for 4C-HSDPA HS-DPCCH |R10|  p. 87
8.10A.1Performance requirements  p. 87
8.10A.1.1ACK false alarm  p. 87
8.10A.1.2ACK mis-detection  p. 88
8.10A.2Applicability of requirements  p. 88
8.10BPerformance of ACK/NACK detection for 8C-HSDPA HS-DPCCH |R11|  p. 89
8.11Demodulation of E-DPDCH in multipath fading condition |R6|  p. 89
8.11ADemodulation of E-DPDCH and S-E-DPDCH in multipath fading condition for UL MIMO |R11|  p. 90
8.12Performance of signaling detection for E-DPCCH in multipath fading condition |R6|  p. 91
A(Normative)  Measurement channels  p. 92
A.1Summary of UL reference measurement channels  p. 92
A.2UL reference measurement channel for 12.2 kbps  p. 93
A.3UL reference measurement channel for 64 kbps  p. 94
A.4UL reference measurement channel for 144 kbps  p. 95
A.5UL reference measurement channel for 384 kbps  p. 96
A.6Void  p. …
A.7Reference measurement channels for UL RACH |R4|  p. 97
A.8Reference measurement channel for HS-DPCCH |R6|  p. 97
A.8AReference measurement channel for HS-DPCCH for 4C-HSDPA |R10|  p. 98
A.9Summary of E-DPDCH Fixed reference channels |R6|  p. 99
A.10E-DPDCH Fixed reference channel 1 (FRC1) |R6|  p. 99
A.11E-DPDCH Fixed reference channel 2 (FRC2) |R6|  p. 100
A.12E-DPDCH Fixed reference channel 3 (FRC3) |R6|  p. 101
A.13E-DPDCH Fixed reference channel 4 (FRC4) |R6|  p. 102
A.14E-DPDCH Fixed reference channel 5 (FRC5) |R6|  p. 103
A.15E-DPDCH Fixed reference channel 6 (FRC6) |R6|  p. 104
A.16E-DPDCH Fixed reference channel 7 (FRC7) |R6|  p. 104
A.17E-DPDCH Fixed reference channel 8 (FRC8) |R7|  p. 105
A.18E-DPDCH Fixed reference channel 9 (FRC9) |R11|  p. 106
A.19E-DPDCH Fixed reference channel 10 (FRC10) |R11|  p. 107
B(Normative)  Propagation conditions  p. 109
B.1Static propagation condition  p. 109
B.2Multi-path fading propagation conditions  p. 109
B.3Moving propagation conditions  p. 109
B.4Birth-Death propagation conditions  p. 110
B.4AHigh speed train conditions |R7|  p. 110
B.5Multipath fading propagation conditions for E-DPDCH and E-DPCCH |R6|  p. 113
C(Normative)  Characteristics of the W-CDMA interference signal |R5|  p. 114
D(Normative)  Regional requirement for protection of DTT |R9|  p. 115
$Change History  p. 116

Up   Top