Network Working Group A. Swartz Request for Comments: 3870 AaronSw.com Category: Informational September 2004 application/rdf+xml Media Type Registration Status of this Memo This memo provides information for the Internet community. It does not specify an Internet standard of any kind. Distribution of this memo is unlimited. Copyright Notice Copyright (C) The Internet Society (2004).
AbstractThis document describes a media type (application/rdf+xml) for use with the Extensible Markup Language (XML) serialization of the Resource Description Framework (RDF). RDF is a language designed to support the Semantic Web, by facilitating resource description and data exchange on the Web. RDF provides common structures that can be used for interoperable data exchange and follows the World Wide Web Consortium (W3C) design principles of interoperability, evolution, and decentralization. 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . 2 2. application/rdf+xml Registration . . . . . . . . . . . . . . . 2 3. Fragment Identifiers . . . . . . . . . . . . . . . . . . . . . 4 4. Historical Considerations . . . . . . . . . . . . . . . . . . 4 5. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 4 6. Security Considerations . . . . . . . . . . . . . . . . . . . 5 7. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . . 5 8. References . . . . . . . . . . . . . . . . . . . . . . . . . . 6 8.1. Normative References . . . . . . . . . . . . . . . . . . 6 8.2. Informative References . . . . . . . . . . . . . . . . . 6 9. Author's Address . . . . . . . . . . . . . . . . . . . . . . . 7 10. Full Copyright Statement . . . . . . . . . . . . . . . . . . . 8
2] can be serialized in many ways, the W3C has defined the RDF/XML syntax  to allow RDF to be serialized in an XML format. The application/rdf+xml media type allows RDF consumers to identify RDF/XML documents so that they can be processed properly. The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14, RFC 2119 . RFC 2048, "Multipurpose Internet Mail Extensions (MIME) Part Four: Registration Procedures" . MIME media type name: application MIME subtype name: rdf+xml Required parameters: none Optional parameters: charset Same as charset parameter of application/xml, defined in RFC 3023 . Encoding considerations: Same as charset parameter of application/xml, defined in RFC 3023 . Security considerations: See "Security Considerations" (Section 6).
Interoperability considerations: It is RECOMMENDED that RDF documents follow the newer RDF/XML Syntax Grammar  as opposed to the older RDF Model and Syntax specification . RDF is intended to allow common information to be exchanged between disparate applications. A basis for building common understanding is provided by a formal semantics , and applications that use RDF should do so in ways that are consistent with this. Published specification: see RDF/XML Syntax Grammar  and RDF: Concepts and Abstract Syntax  and the older RDF Model and Syntax  Applications which use this media type: RDF is device-, platform-, and vendor-neutral and is supported by a range of Web user agents and authoring tools. Additional information: Magic number(s): none Although no byte sequences can be counted on to consistently identify RDF, RDF documents will have the sequence "http://www.w3.org/1999/02/22-rdf-syntax-ns#" to identify the RDF namespace. This will usually be towards the top of the document. File extension(s): .rdf Macintosh File Type Code(s): "rdf " For further information: Dan Brickley <firstname.lastname@example.org> RDF Interest Group <email@example.com> More information may be found on the RDF website: <http://www.w3.org/RDF/> Intended usage: COMMON
Author/Change controller: The RDF specification is a work product of the World Wide Web Consortium. The W3C and the W3C RDF Core Working Group have change control over the specification. Section 4.1 of the URI specification  notes that the semantics of a fragment identifier (part of a URI after a "#") is a property of the data resulting from a retrieval action, and that the format and interpretation of fragment identifiers is dependent on the media type of the retrieval result. In RDF, the thing identified by a URI with fragment identifier does not necessarily bear any particular relationship to the thing identified by the URI alone. This differs from some readings of the URI specification , so attention is recommended when creating new RDF terms which use fragment identifiers. More details on RDF's treatment of fragment identifiers can be found in the section "Fragment Identifiers" of the RDF Concepts document . RFC 3023 , saying: RDF documents identified using this MIME type are XML documents whose content describes metadata, as defined by . As a format based on XML, RDF documents SHOULD use the '+xml' suffix convention in their MIME content-type identifier. However, no content type has yet been registered for RDF and so this media type should not be used until such registration has been completed. Section 2.
RFC 3023 , section 10, discusses security concerns for generic XML, which are also applicable to RDF. RDF data can be secured for integrity, authenticity and confidentiality using any of the mechanisms available for MIME and XML data, including XML signature, XML encryption, S/MIME, OpenPGP or transport or session level security (e.g., see , especially sections 3.4, 3.5, 3.10, , , ). RDF is intended to be used in documents that may make assertions about anything, and to this end includes a specification of formal semantics . The semantics provide a basis for combining information from a variety of sources, which may lead to RDF assertions of facts (either by direct assertion, or via logical deduction) that are false, or whose veracity is unclear. RDF application designers should not omit consideration of the reliability of processed information. The formal semantics of RDF can help to enhance reliability, since RDF assertions may be linked to a formal description of their derivation. There is ongoing exploration of mechanisms to record and handle provenance of RDF information. As far as general techniques are concerned, these are still areas of ongoing research, and application designers must be aware, as always, of "Garbage-in, Garbage-out". 13], to Andy Powell for <http://www.w3.org/2000/03/rdf- tracking/#mime-types-for-rdf-docs>, to Marshall Rose for his <http://xml.resource.org/> converter, and to Graham Klyne, Jan Grant, and Dave Beckett for their helpful comments on early versions of this document.
 Beckett, D., "RDF/XML Syntax Specification (Revised)", W3C rdf- syntax-grammar, February 2004, <http://www.w3.org/TR/2004/REC- rdf-syntax-grammar-20040210/>.  Klyne, G. and J. Carroll, "Resource Description Framework (RDF): Concepts and Abstract Syntax", W3C rdf-concepts, February 2004, <http://www.w3.org/TR/2004/REC-rdf-concepts-20040210/>.  Hayes, P., "RDF Model Theory", W3C rdf-mt, February 2004, <http://www.w3.org/TR/2004/REC-rdf-mt-20040210/>.  Murata, M., St.Laurent, S. and D. Kohn, "XML Media Types", RFC 3023, January 2001.  Freed, N., Klensin, J. and J. Postel, "Multipurpose Internet Mail Extensions (MIME) Part Four: Registration Procedures", BCP 13, RFC 2048, November 1996.  Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997.  Lassila, O. and R. Swick, "Resource Description Framework (RDF) Model and Syntax Specification", W3C REC-rdf-syntax, February 1999, <http://www.w3.org/TR/REC-rdf-syntax>.  Berners-Lee, T., Fielding, R. and L. Masinter, "Uniform Resource Identifiers (URI): Generic Syntax", RFC 2396, August 1998.  Bellovin, S., Schiller, J. and C. Kaufman, Eds., "Security Mechanisms for the Internet", RFC 3631, December 2003.  Rescorla, E., "HTTP Over TLS", RFC 2818, May 2000.  Eastlake, D., Reagle, J. and D. Solo, "(Extensible Markup Language) XML-Signature Syntax and Processing", RFC 3275, March 2002.  Eastlake, D. and J. Reagle, "XML Encryption Syntax and Processing", W3C xmlenc-core, December 2002, <http://www.w3.org/TR/2002/REC-xmlenc-core-20021210/>
BCP 78, and at www.rfc-editor.org, and except as set forth therein, the authors retain all their rights. This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/S HE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Intellectual Property The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the ISOC's procedures with respect to rights in ISOC Documents can be found in BCP 78 and BCP 79. Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at http://www.ietf.org/ipr. The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at ietf- firstname.lastname@example.org. Acknowledgement Funding for the RFC Editor function is currently provided by the Internet Society.