tech-invite   World Map     

3GPP     Specs     Glossaries     Architecture     IMS     UICC       IETF     RFCs     Groups     SIP     ABNFs       Search

Top          in Index          Prev          Next

draft-TS 38.141 (RAN4)
NR – BS conformance testing

|   ToC   |   3GPP‑Page   |   ETSI‑search   |   Help   |

(W-zip) V0.0.3    2017/08    11 p.


Rapporteur:  Dr. Chen, Xiang (Steven)
See also:  –


The present document specifies the Radio Frequency (RF) test methods and conformance requirements for NR Base Station (BS). These have been derived from, and are consistent with the NR BS specification defined in TS 38.104. The technical specification is in 2 parts, part 1 covers conducted requirements and part 2 covers radiated requirements.


 

Here          Top

 

1 Scope    2 References    3 Definitions, symbols and abbreviations    3.1 Definitions    3.2 Symbols    3.3 Abbreviations    4 General conducted test conditions and declarations    4.1 Measurement uncertainties and test requirements    4.2 Conducted requirement reference points    4.3 Base station classes    4.4 Regional requirements    4.5 Applicability of requirements    4.6 BS configurations    4.7 Manufacturer's declarations of regional and optional requirements    4.8 Test configurations    4.9  RF channels and test models    4.10 Format and interpretation of tests    4.11 Requirements for contiguous and non-contiguous spectrum    4.12 Requirements for BS capable of multi-band operation    5 Operating bands and channel arrangement    6 Conducted transmitter characteristics    6.1 General    6.2 Base station output power    6.3 Output power dynamics    6.4 Transmit ON/OFF power    6.5 Transmitted signal quality    6.6 Unwanted emissions    6.7 Transmitter intermodulation    7 Conducted receiver characteristics    7.1 General    7.2 Reference sensitivity level    7.3 Dynamic range    7.4 In-band selectivity and blocking    7.5 Out-of-band blocking    7.6 Receiver spurious emissions    7.7 Receiver intermodulation    7.8 In-channel selectivity    8 Conducted performance requirements    A [N] Characteristics of interfering signals    B [N] Environmental requirements for the BS equipment    C Test tolerances and derivation of test requirements    D Measurement system set-up    E Change history   

 

1   Scope   Word-p. 6
2   References
3   Definitions, symbols and abbreviations
4   General conducted test conditions and declarations   Word-p. 7
5   Operating bands and channel arrangement
6   Conducted transmitter characteristics   Word-p. 8      Up
7   Conducted receiver characteristics   Word-p. 9
8   Conducted performance requirements   Word-p. 10
A  (Normative)   Characteristics of interfering signals   Word-p. 11
B  (Normative)   Environmental requirements for the BS equipment
C   Test tolerances and derivation of test requirements
D   Measurement system set-up
E   Change history

Up          Top